Sosakonline Archive

Please note that all content in this section has been imported from our old Sosakonline website and may contain broken links. We are revising it as we can, but these things take time, and it's a lot of content to get through!

I rarely use brand new knives for Mods, but I had to do it for this one. I ordered a pair of Cybertool 29s from Nuts4knives at the same time I got my Victorinox Spirit (a great deal, I might add - thanks Rich).

What I was after was a SAK to that would replace the full sized screwdrivers that I normally carry in my Laptop bag; I thought a stripped down Cybertool might fill the bill.


I envisioned a knife with the compactness of a Scientist and the screwdriver bits I need on a daily basis to handle computer case screws.



The resulting knife ended up wider than anticipated. The removal of the cap lifter/can opener layer did not result in a significant reduction of thickness due to the width of the bit holder/bit case layer. I am left thinking that I could have saved myself the trouble and used the knife in its factory configuration.

Here it is between a Cybertool 29 and my home brewed Scientist:



The bit wrench/bit case layer has some specialized parts associated with it. There are two wishbone shaped springs and two special liners.



The special liners cannot be omitted as they form a stop/support for the bit case when it is in the closed position.